Best tool for the job?

I'm getting tired of using my fingers to push in cables and ribbons on small form factor PCs. Doing 2-3 computers like this is one thing, but when you have 200+ it's time to get a tool for the job. I know there is no specific tool for this, just wondering what others have used. I'm thinking angled forceps might be the ticket.

Anyone know of a good tool that lets you safely pull a sata plugs and 9-Pin ribbons.

https://cdn.iofferphoto.com/img3/item/565/862/985/prKJserial-9pin-rs323-db9-motherboard-com-port-ribbon-cable.jpg

http://ss4200.pbworks.com/w/page/5122741/f/IMG_2187.jpg

Posted Apr 11, 2014, 6:06 PM UTC

13
bigj231•

I use my leatherman when I can't use my fingers, but I usually just man up and pull. Forceps would work as well.

1
CareerRejection•

The forceps might help but you will lose some dexterity and speed, at least until you get used to it I suppose. If you do it enough times, the skin on your fingers will end up with callouses to help with the pain.

1
Reloader45ACPOP•

I just finished a 30 PC deployment for a bank and I have a dozen other sites coming up. Lately we've been buying Dell Optiplex 3020 series machines. Before that it was the 3010 and 390 series. All the computers require an extra serial RS232 with a 9-Pin plug to be installed. Looks similar to the USB 9-Pin port.

On the Optiplex line, the male port on the motherboard is next to the CPU, but right under the toolless chassis hinge. So you can't go straight down and plug it in. I normally have to bend the serial ribbon and push it in at an angle. Then I use the eraser end of a #2 pencil or a flathead screw driver to push the connector into the jack.

Not a big deal when you only have a few PCs to setup, but a real PITA when you have 100+.

1