tryin_to_weldCombo Pipe-Fitter/Welder (V)•

Did you check your push rod before putting the rocker back in place?

3
learning_arcOP•

Tightened back down, runs fine. Dad was positive it was a seized valve. Miller trailblazer 275 with the Kohler engine

2
PBRBeer•

You can remove the rocker arm and hit the valve stem with a plastic dead blow hammer, you will immediately find out if it's a stuck valve then, a normal valve will depress and spring back, you can feel it when you strike it, Make sure the piston is down in it's stroke before you do this, put a zip tie down the spark plug hole and follow the piston's travel down.

1
three_word_replyGTAW/FCAW/SMAW SS, Al, Cr, Superalloys•

Removed: not related to this sub. Try r/justrolledintotheshop

1
learning_arcOP•

How so? Its a welding machine..and I checked everything the manual said to. All checks out. I didn't have it running any load so im going to try it in the morning.

1