94 Chevy S10 Blazer 4.3 CPI

Want to take the fan out and install an electric fan or duel electric fans. Never done this before so I'm kind of teaching myself, and I'll take any advice I can get.

Posted Sep 1, 2014, 1:17 AM UTC

65
waynep712222•

why... the factory belt driven fan cools so well.. is properly matched to the engine needs.

if you install a pair of radiator cooling fans.. you will have to perhaps increase the alternator output by swapping in a larger amp alternator.. electric fans also DO NOT run all the time.. they are supposed to switch on and off as the thermostat opens and closes.. the thermostat opens and allows hot coolant into the radiator.. the cooler coolant in the radiator goes into the engine and the computer sees the drop in temp on the engine coolant temp sensor and it commands the fans on for a specific time. that is just enough to take the heat out of the stationary coolant in the radiator..

the fan clutch has a bimetallic strip on the front to do the same thing.. as the thermostat opens.. the hot coolant rushes into the radiator.. the fan is spinning at reduced speed. the hot coolant heats the coil of bimetallic spring. this changes the flow of the silicone oil in the fan clutch to increase the torque transferred to the fan blade to cool the hot coolant in the radiator.. as the radiator cools the temp of the air across the spring is relaxed and the fan idles again.. its hard to beat a belt driven fan..

some of the later models do use dual electric fans and similar sized radiators.. so you might look for a dual radiator fan assembly to just install in your truck.. look at how the wiring to the relays is installed also..

2
RotPitOP•

Trying to take all unnecessary loads off of the motor before I add power. I can feel the fan spinning at low RPMs and it bothers me like you wouldn't believe. So I'm starting there.

1
waynep712222•

but it takes a similar amount of power to spin the electric fans using 14 volts created by the alternator..

perhaps your fan clutch has failed.. and is seized up.. i have a friend with a 91 and his failed.. he could not drive the truck over 35mph.. as the fan was pulling so hard it could not overpower it. sounded like a jet plane trying to take off..

3
imprl59•

If you want to do it the cheap way there are several different fan assemblies that are common in the junk yard you can use. The taurus fan is a common one that is used, electrics from a camaro or other lt1 powered vehicle will bolt right in. The dual fan setup from an Itrepid works well too. You can find wiring kits all over the place. It's not hard but something that you can reasonably expect to be able to figure out on your own.

http://www.carforum.net/engines/10491-installing-electric-rad-fan-s10-s15-blazer.html is a pretty good writeup on how to do it, he used the Chrysler fans

2
RotPitOP•

Badass, Thanks!

1