r/fixit•
Number_06

Need to enlarge a hole in a door

I want to replace a doorknob on an interior door. The hole in the edge of the door where the latch goes is just a hair too small for the new latch assembly. What's the best way to enlarge it?

Posted Jan 14, 2015, 2:42 AM UTC

29
Szos•

From your description, it sounds like just a little bit of sanding should do it. Or get a small chisel to remove a little more material out.

If it was more than just "a hair too small" then I'd say to drill it out, but depending upon which hole it is, it might be a family large drill bit size which most regular homeowners won't have laying around.

3
[deleted]•

Do you mean the crossbore?

If "hair too small" means you can drill it out, then get yourself a 1" bit and run it through a few times, wiggle it a bit as you do to increase the actual diameter of the crossbore.

Also note that you may need a chisel for the latch (the rectangular bit on the edge of the door). Most latches are close to being the same dimensions, but sometimes you need to work at it a bit to get it to fit precisely.

Used to work as a locksmith. Saw a lot of this stuff on installs.

2
Number_06OP•

Yes, I didn't know that hole was called the crossbore. The rectangular part fits. What is too big is the sleeve holding the internal moving parts that goes inside the crossbore. I'll measure it and see how big a drill bit I need. Thank you. :)

1
inibrius•

you honestly don't need a drill bit as big as the whole hole, just one long enough. Basically keep the drill at medium speed and run it counter-clockwise along the inside bore of the hole to widen it a little at a time.

4
Number_06OP•

Thank you. Should I use a paddle bit or a regular spiral bit?

1
inibrius•

spiral bit will be easier to control, nothing to bite into the sides.

3
[deleted]•

Yeah, 1" is standard; kinda weird that your new latch wouldn't fit.

Also note from this web page that there are two "back set" lengths: 2-3/8" and 2-3/4". Make certain you have a latch with the correct backset. Quick video how-to.

(Backset is from the edge of the door to the center of the bore hole.)

2
Number_06OP•

This door has been here since the late 1950s, and there are some other crazy things in this house. I'm not surprised it's odd. Thanks again for your help.

1