Looking to make a kiln for tempering, dimension question
I am in the planning stages of making a kiln, and I only want a kiln that will do only one blank at a time. Having a width of 4.5" and 4" high, do you think I will run into issues? Does it matter how far the elements are from the knife? (obviously not touching because they can short) What do you think?
edit: Please excuse crappy paint skills, elements will be drilled in channels on the sides. Do you think this is enough room? Here is my plan. In case you were wondering.
Posted Mar 8, 2015, 11:17 PM UTC · edited
I've looked into doing the same, and with a 240v element you can do as large as you like; they make jewelry kilns that are about as small as you mention so that's definitely doable as well, even at 120v. What depth are you talking about here? The only thing I can imagine being a problem with a small kiln is whether or not you can cram an entire heating element in there, as shortening a pre-cut kanthal element will change its resistance and therefore potentially its heating characteristics and the voltage you have to run it at. If you can coil the whole element up and fit it in the kiln, no problem--or if you're doing your own electrical calculations, that's also fine, if more involved.
Yeah I have the element part figured out, I am just worried if the blades are within an inch of an element would it would throw off heat treat?
Not really for annealing/normalizing/hardening heats, but maybe for tempering if you plan on using your oven for that too. If you were worried, you could put the blade inside a stainless steel (or copper, if only at low heat) tube, which will reduce the risk of radiant or convectional heat spikes on the blade. If you're just making knives though I'd use a toaster oven and keep the heavy-duty one for hardening. I use a coal forge for hardening and it works just fine despite the imprecise temperature control.
Ok I will probably hit up craigslist for the tempering oven when it comes time.