Coffee Brewing Stand - Steam Bending Fun!
imgur.com/a/wnYd3Posted May 21, 2015, 4:52 PM UTC
Posted May 21, 2015, 4:52 PM UTC
This is great! Did you have to overbend the angle so when unclamped, it would be that nice curved to 90 degree turn? Or was steaming and clamping using your jig enough to keep it in form? Awesome work
The bent arms are actually 3 ply. I did this because I wasn't sure about how much spring back would occur. The process I used was to steam the 3 pieces for an hour and then clamp them in the form over night. The next day I would pull them out of the form, glue the layers together and stick them back into the form to cure.
The glued ply approach seemed to eliminate spring back and made for strong pieces. The only tricky part was getting even clamping pressure during the glue up to ensure there were no gaps. For a couple of areas I had to re-glue and clamp outside of the form to close up the joints.
When I do it again, I will likely change the form so that it can be more like a press mold so that all the surfaces receive even pressure, especially in the curve. The fixture may have to be more vertical, not 100% sure though.
Cool, thanks a lot
I think for your mold you can take this same shape, and drill a series of big holes all along the edge of the centerpiece, which you can then insert the nosed of clamps into. Then split the outside piece into many small pieces and clamp them one by one via the holes. That way you'll have more even pressure and you can use more smaller clamps.
Not a bad idea, and an excuse to by more clamps!
Good luck! You can never have enough clamps.
You could use a metal brace as a backing to support the pieces being bent and even out the pressure as well.
Have to be careful of metal due to staining as the wood is hot and wet.
Rubber gasket,wax paper,brown paper.
Really cool, I'd buy one of those!
Thanks! I have been considering an Etsy store...
Ditto! Bookedmark for later inspiration and so I can reverse engineer that steam box!
You should definitely sell these. That's pretty awesome. What are you using to generate the steam?
Looks like a stock pot with a modified lid sitting on a hot plate underneath the steam box. The pipes go back into the lid of the stock pot so condensation returns to the pot.
If you have any pictures I'd like to see them. I'm thinking about trying some very small scale steam bending soon. I have one of those hand held steam generators used for cleaning, but it's definitely not going to provide steam for long enough.
For small stuff you could definitely use the small steamer and thick heat proof plastic bag. I actually had good luck with just dropping a small piece of oak into a bot of boiling water for a few minutes.
Shipwrights seem to know whats up when it comes to steam bending:
[deleted]
Thanks! The steam is made in pot of water on a hot plate and I used some old pool equipment piping and fittings to run it up into the box.