Aeolus V2 Pro, a quick review.

So I ordered this atomizer directly from Syntheticloud on July 3rd. It took them 6 days to ship, and another 6 days to get to me from California. All the while I got more and more intrigued to see it for myself. I was pretty excited to add another authentic Atty to my collection. I cracked open the packaging after work today and was impressed with the looks of the Atty. It's sleek. Very sleek, small, well machined and clean. I followed the little instruction packet that it came with. I cleaned it, tightened down the screws that hold the deck together, screwed the barrel on and off and got ready to build. Then I remembered that I had also ordered the drip top and got super excited. I found it in the package and excitedly put it on the top cap. It doesn't fit. AT ALL. It slips on and off and falls off if I even so much as bump the damn thing. Problem number one. Then I built it. 8 wraps 22awg nichrome on a 3mm screwdriver. The build came out to just shy of .2 ohms. I wicked it and screwed the barrel on. Or at least tried to. The moment I got the barrel even close to tight, it unscrewed the Atty. Reverse threaded barrel was a bad, bad move. Problem number 2. I got the barrel on finally and noticed that even with the barrel screwed all the way down and the Atty as tight as it could get on my mod, there was still a gap caused by the ridiculously long 510 connector. The gap is about a half millimeter, but noticeable and annoying. As of now I cannot get the goddamn thing to sit flush on any of my mods. Problem number 3. If you can overlook the problems above, its a solid little Atty, until you vape at high wattages. This thing gets HOT, almost scalding hot. Problem number 4. All in all its not a terrible atomizer, not worth the 85 I paid for it and the drip top, especially considering the drip top doesn't even fit. I'll keep using it out of how stubborn I am, and because the vape is really nice and the flavor is crazy good. All in all I give it a 6/10.