Fiberglass shower shell has low spots and won't drain properly. Any way to repair without fully replacing?
To give some context, we bought our house back in 2013 and it was a flip. It was our first house and honestly we didn't know certain things to look for and over time we've realized that the flipper didn't know what the hell he was doing. The first day we were in the house after all was said and done I decided to clean up after a long day of moving in and discovered that the idiot had installed the shower shell incorrectly and it has a low spot on both sides of the drain so it does not drain.
Over the past few years we've been using a squeegee to get most of the water to the drain, but as you can see from the pictures it's starting to stain and it's really just a pain in the ass to do every day.
Is there any way to fix these low spots without tearing out the entire shower? It is a one piece fiberglass shower stall.
I haven't been able to find any info online, but I've found some people that have reinforced their shower with Great Stuff expanding foam (the low expansion kind), but they had access to the wall behind the shower. I don't have that capability, so I'd need to potentially drill in to the fiberglass and then use epoxy to fill the hole. I'm just afraid that'll be dangerous if I overfill, or a waste of time. Would this work in theory? Any other ideas?
I'm getting a few more quotes tomorrow from plumbers to replace the whole thing, but the two I've received so far have ranged from $1500 to $4000.
Pictures in the album below, sorry they're not great: https://imgur.com/a/GlXTG
Posted Apr 7, 2016, 7:06 AM UTC
Tricky but certainly do-able. Mask a section at ankle height and give the floor a light sand with some 1200 wet and dry sandpaper. Drill a hole through each low spot and build a small dam with a strip off cellophane around the waste. Colour match your showers Gel-Coat with some self leveling liquid epoxy. It's the stuff they use for making concrete floors look sexy. Into your holes you inject a slurry of grouting compound until it stops filling..I've used a caulking gun successfully for this.Then after a few hours you pour your self leveling epoxy into your shower base until you get a nice even coating. You're still going to have to get under the shower from below to make sure your grout mixture doesn't ooze through waste pipe penetrations and such. If there are any obvious gaps from below you can seal them up with expanding foam. It's step by step and possible for a smaller amount than a replacement.