Anyone get in their E3D Titan yet? Use inductive auto bed leveling?

This Titan setup on a Prusa I3 anyway, isn't very good. The motor should really go out the back. As it is, I'm losing bed width, and my inductive auto bed probe mounting solution isn't the greatest. Or reliable. Trying to figure out how to fix that. The only place I could mount it was to the motor itself, coming off the front of the setup which is about 50mm away from the hot end. Not good.

Was excited to get this up and running, but printer may need to stay down until someone comes up with a better mounting system for inductive sensor folks. For those of you using that system with their Titan on order, I'd hold off taking it apart until then.