Removing Ruthenium
Been doing a RuCl3/NaIO4 oxidation of an alkene to the corresponding acid.
Leats to lots of black goo being formed that I can't really remove from my product. Tried filtering (Celite) but didn't really help too much. Just runs straight through the column and I get a greenish/black product instead of white.
Anyone has experience/suggestions how to remove the Ruthenium compounds from my product ?
Posted May 23, 2016, 5:44 AM UTC · edited
It is yellow RuO4 in the organic phase turning into black RuO2 colloids. There are two good ways to prevent RuO2 formation A) concentrating the reaction mix on rotovap while NaIO4 still present - RuO4 is volatile and will go into rotovap with organic solvents (in the classic Sharpless procedure it was CCl4+MeCN) B) after extracting the product away from periodate/iodate inorganics, washing the organic extract immediately with aqueous thiosulfate. Ru is very thiophilic. But it is important to do so before the mix starts turning black. RuO2 is pretty stable and slow to dissolve.
That's crazy how volatile the RuO4 is
[deleted]
Yeah. At this point, run a short silica plug. It should stick to the silica. I would advise against rotovaping off the ruthenium tetroxide-I don't like what that can do to your pump.
silica does not work in this case - the dark colloids stick with the carboxylic acid product throughout the column, and the product is very dark as a result, not really a problem for chemistry (unless it is a final product) but it sucks to have dark discoloration. Also RuO4 is not a problem in the pump, presumably you would have dry ice cold finger rotovap and teflon pump, and RuO4 is reduced immediately to RuO2 by whatever is in the rotovap. Only cleaning the dark deposits from rotovap is unpleasant.
Screw the pump, I don't like what it can do to my lungs.
Doesn't work. Even after running a full column the stuff stuck with my product.