Hot air station repair
My rework station stopped blowing hot air due to a burned heating coil. The replacement is already on its way, but of course I had to have a look inside. As a result I would now like to stock up on kanthal wire to reduce downtime the next time this happens.
However there is a sheet of something wrapped around the heating module that I don't know what to replace it with. Its function is to provide electrical insulation and it needs to be very heat resistant. It seems to be glass fiber reinforced, judging by the way it disintegrates.
What is the electrical insulation sheet made of and where can I buy some of it? Also I wouldn't mind more insight about heating wires. It looks like kanthal on ebay right now is more expensive than it should be due to vapors.
Posted Aug 18, 2016, 11:37 AM UTC
The insulation is probably just whatever high temp insulation was cheapest. You could probably buy a sheet and cut it to size as you need it. I don't have a specific recommendation but in the past I've used insulation meant for bbq grill/smokers in similar applications. Kanthal is a fine resistance heater wire but as you've seen its heavily used by vapers. That being said it still should be fairly cheap (3-5 bucks) to get a roll of 50yds unless prices have gone way up since the last time I bought some
After some more searching the web I'm pretty sure it's mica in english and glimmer in german I'm looking for. 350$/ton is a reasonable price,too. /s
The biggest problem with finding mica is that sheets for grills look to be very stiff and pretty thick.
Mica is like slate, it splits into thinner sheets very easily.