TFV8 NoAtomizer noatty atomizer short **RESOLVED**

so i recently bought a TFV8 for my rx200 and i went through the Q4 and The Q8 with no problems. but when i put the fresh build it came with, my mod started showing no atomizer or atomizor short. i thought it was a screw so i tightened and replaced them but no luck. then i thought it was the build so i threw on DUAL Anarchist 22 Guage 8 Wraps still i was getting the wrong ohms should of been between .15 and .19 but it was .27 so i knew something was up.

1. the premade coils worked fine
2. my mod read the pre made coils accurately
3. the mod was always tight and flush with the body.
4. the pre made coils had a full center pin CIRCLE on the bottom.

Now i through on the RBA and the ohms arent right i screw it and unscrew only to be a quick fix for the problem. i took the rba out and pushed the center pin and it poped right out and i looked at the RBA and it had half a circle not a full circle like the premade coils so i knew the short had to be their.

So leaving nothing to chance:

1. i unscrewed the center pin from the RBA

2. poped out the center pin from the tank (making sure not to loose the insulators)

3.cleaned every thing up from top to bottom and inbetween

4. screwed the airflow to my mod TIGHT

5. put the RBA back together and THEN screwed that on TIGHT

6. left my old coils on their the whole time.

7. wicked it, filled it, vaped it.

My ohms went down to .17 (where its suppose to be). and its been two hours and not a Short in sight.

i hope this helped if anyone is having the same issue. it drove my crazy.