r/networking•
Bottswana

Cisco - 802.1x authentication disappears on switch reload

Hello folks.

I have port authentication enabled on my C3650 switch. This all works fine. An example of the configuration looks like:

dot1x system-auth-control
interface gigabitEthernet1/0/10
    dot1x pae authenticator
    authentication port-control auto

This all works fine until the switch is reloaded, when the directives are missing from the interface in running-config. The serial interface lists this on boot:

 authentication port-control auto
    ^
Invalid input detected at '^' marker.

dot1x pae authenticator
    ^
 Invalid input detected at '^' marker.

I can't seem to find a solid answer as to the problem here. If I go in and add the two lines again after boot it takes them and authentication works again.

Any help would be appreciated! Thanks

Posted Nov 3, 2016, 4:22 PM UTC

513
Loading comments…