Looking for a latching relay
I replaced the hatch of a Passat 3b5 with one for the 3bg and now have to find a solution to cope with the changed locking mechanism. Before it was mechanical with servo locking/unlocking now it is fully electrical. When the car is locked and I push a switch nothing should happen. If the car is unlocked and I push the switch a motor should start running to pull the lever opening the hatch.
For that I need something that has 2 states (locked and unlocked), that I can put in place of the original locking servo . It switches to either of those states when voltage is applied to one of its 2 input pins. In the unlocked position it allows current to flow from the switch to the locking mechanism. In the locked position it doesn't.
As a sort of electrical engineer to me that is a variant of a latching relay. Could you guys help me out and give me a better name or even tell me the V.A.G. relay number?
I haven't given up being able to reconfigure the control module, yet. But the solution described above would do just fine if the control module between very late 3b5 and 3bg did indeed change.
Edit: clarification
After a bit more searching the internet I now know how the relay I'm looking for works, but still have no clue how to buy one: Two coils move the contact when energised. When no coil is energised the contact remains in it's previous position. One coil energised makes contact. The other coil energised breaks contact.
...and after more digging: It's called a "mechanically latching dual coil SPST relay" (I don't care about the number of poles and throws). Even after giving up on an automotive specific relay I still can't quite find one I can actually buy. It's used in train signalling apparently.
Posted Dec 15, 2016, 7:56 PM UTC · edited
SCR inline with a normal relay? But that won't work if the car was unlocked before the master switch was turned on. A reed switch to detect the lock pushrod position may be the ideal thing.
To make a latching relay, just solder a shunt from Switched Closed and Switched to power the relay.
There is no lock pushrod. The only difference between a locked and unlocked hatch is whether the button works. That's why I need a latching relay to safe the locking state.
What is an SCR? Silicon Controlled Rectifier? If that's the case I don't see how that helps.
Latching relays exist. I will not drain the battery to safe state.
An SCR can be made into a low power latch. When it receives a low on "unlock", it can hold that state until power is blipped - which could be a low on "lock". I'm not sure if a latch is actually what you're looking for.
There will be a pushrod in the doors that can be used to detect lock state.
By push rod you mean the light switch? That does in fact not exist. The locking state of the four none-hatch doors is detected by micro switches inside the locking mechanism. And those break often enough that I wouldn't rely on those. In fact currently the car alarm is disabled because of one or more of those damn switches.
I made another edited to my initial post describing how I now know the relay I'm looking for works.
Saving the locking state in a way that depends on the battery to stay connected I really dislike. Even If I made sure it defaults to locked on power failure I'd still not feel comfortable with such a solution.
Edit: On second thought I think by push rod you mean the pushing part of what I called a servo. I could indeed use the old one and make it push a switch instead of actuating the locking mechanism. That would be quite the post to r/justrolledintheshop
Well you want a linear push-pull servo latch then - not a latching relay. It normally has a cam-spring on a shuttle and an electromagnet that you reverse polarity on to change the closed side.
The difference is a latching relay will reset the moment it loses power.