Reason one side of print looks terrible?

Posted Mar 22, 2017, 4:29 PM UTC

Posted Mar 22, 2017, 4:29 PM UTC
Bed is not level.
Bed Temp of 110C for PLA? Turn that down a bit. That's over kill.
Like others said, bed leveling and under extrusion look to be the problem.
Details: Lulzbot Taz 6 using colorFabb PLA poly. Nozzle temp is 230. Bed is 110. Other end of print looks fine but this end is clearly not OK. Pretty new to 3D printing and trying to troubleshoot. Use Simplify3D to slice.
u/ReaverKS hit the nail on the head but dial in those temps too. I have never printer PLA with a bed above 70. I don't know why you are running it at 110.
Thanks. Not sure where I got that bed temp. Their own profile for the material shows the bed should be at 85. Going to lower that and look at increasing extrusion. The bed is physically level - just checked with a machinist's square. I'm assuming the leveling setup it does before each print is accurate but not sure where to check that. Thanks for the feedback.
Do an e step calibration too. This helped with my underextrusion.
Doing that now. Following a guide u/reaverKS pointed out. Thanks!
Try it using the Cura profile, if it comes out better then you can rule out any machine issues and know its simplify3d settings related
Good call. Will print it with Cura now to see how it does. Lowered bed temp to recommended and checked the surface with machinist's square. It's physically flat, and I thought the leveling is done by that four corner touch it does prior to the print?
Crappy filament and bed is not level.
https://www.simplify3d.com/support/print-quality-troubleshooting/
Do you have a bowden? seems like could be under extrusion due to bowden constrictions, or something pulling on the head.
Just wanted to add, even if your bed is level in the corners that doesn't mean it's level all around. I get this sort of thing on my MK3 clone bed which is bowed 0.2mm in the middle. 5-point auto leveling really helps fix that.
Bed is not level and it also looks like underextrusion. Look around your rectangles, see how the lines don't run right up to where the rectangles are, it stops slightly short? That looks like underextrusion to me
Adjusting things now to try another print. Thanks for the feedback. Bed is physically flat and it's doing the four corner touch for software leveling. Not sure what else I should be doing for that.
I'm not intimately familiar with the taz 6 but I'd take a straight edge and lay it on it's edge on the bed and then shine a light through the bottom. Ensure the bed itself is level. I don't know if it uses an inductive probe for the leveling, but if that's the case I'd make sure the inductive probe is away from the bed while the bed is heating up as temperature and humidity can impact the sensors accuracy. I also noticed in another post you were using a bed temperature of 110 for PLA which is incredibly way too high. I use 50 or maybe 60 for PLA.
As for your underextrusion issue, this can be resolved a lot of different ways. The most complicated but most significant thing to do first is to calibrate your steps/mm of extrusion. Search youtube for Tomas Solander's video on extruder calibration
Thanks again. Used a machinist's square to check that the bed surface itself is level. I use the same tools for woodworking so I trust them. Looks OK.
Lowered the bed temp significantly and I'll check for that YouTube video right now. Really appreciate the feedback!
Printing perfectly now! Lowered bed temp and calibrated the extruder. No more odd extrusion and no gaps between outlines and fill. Really appreciate the quick feedback. Thanks again!
Great, glad I could help!