r/AskElectronics•
red_nuts

RF noise from Cockcroft-Walton multiplier

Troubleshooting

For my geiger counter project, I've constructed a 400V power supply that uses a Cockcroft-Walton multiplier. It works very well, but I am detecting a lot of RF noise coming from it.

I'm using exactly the circuit shown below in this image from Wikipedia:

https://upload.wikimedia.org/wikipedia/commons/7/7b/Cockcroft_Walton_voltage_multiplier_circuit.svg

Driving this circuit is a little step-up transformer which is switched from 10 volts by a transistor at 30Khz.

Using a little piece of wire on my oscilloscope probe, I have determined that the biggest source of RF noise is capacitor C1 and C3. Capacitors C2 and C4 are actually very quiet in comparison. When I put the wire next to C1, it generates voltage of 4V P-P !

This is a problem on a breadboard, but this circuit will be going on a PC board, with a ground plane and grounded pours. I'm trying to get some sense of what kind of problem this noise will be in that case, as I need to get a cleaner pulse signal from my geiger tube than what I currently have.

I'm also wondering what effect the capacitor type will have on this. Right now I'm using big mylar caps. Turning the cap around in the circuit has no effect on how much noise there is. Is another type less prone to emitting RF noise?

Is there any other suggestion for reducing the noise emitted from these caps? Thank you very much.

Posted May 2, 2017, 6:56 PM UTC

78
Loading comments…