Issue with new Uberti 1860 Army revolver and removing the barrel from the frame.
Hello all, so I have, as the title states, an Uberti 1860 Army repro that's straight from the factory. Yesterday I tried to disassemble it to clean it before firing, but after removing the barrel wedge and pushing the loading lever against the cylinder, I found that I could not remove the barrel. Ended up firing it anyway with the hopes that it would shake loose a little, but this wasn't the case. I then spent hours trying to pry the barrel from the frame without causing damage, and was eventually able to by placing the loading lever against the edge of a table and smacking the grip with my palm. It finally came loose and I was able to clean it, I made sure to clean and grease the area where the cylinder pin met the barrel to ease its future removal, but it ended up being equally difficult to put it back on. From what I understand, it isn't supposed to be that tight of a fit, so is there anything I can do to improve the ease with which the barrel departs from the cylinder pin?
Posted May 28, 2017, 2:10 AM UTC
Sand paper the pin that the cylinder spins on, but only sand the front part that goes into the barrel part, not where the cylinder spins on it. Unless, that is tight also. Take your time and sand carefully, don't take off too much so it is a sloppy fit.
Will try it and hope for the best.