[Tips for vaping stims] just hotrailed 30 mg of a-PVP through a small meth bong (without water in it) after a small tolerance break

The rush is pretty amazing, now I can definitely see for this stuff takes people to the shadow realm. I just did a small tolerance break (too small in my opinion), but I got the opportunity to experiment around a bit and decided to try something out (against my better judgment probably). I wanted to make this post for everyone who enjoys vaping stimulants or wants to try it out.

So, let's get to the tips promised. I played around a bit and wanted to write up a little (or huge) text on how to get some pretty nice results when you want to vape stimulants (out of oil burners/meth pipes).

1. A bong. That's right, you can take a bong you have, or like me, buy a small one because I don't really smoke weed more than a few times per year, and get an oil burner/vaporizer attachment for them. A dabbing nail works too, but I prefer the oil burner with attached downstem (can be used as a meth pipe without the bong).

• I got a tiny bong (~10 cm high, borosilicate glass and has a carb) and an oil burner stem, put the a-PVP in and vaped it without any water, because some people say meth bongs shouldn't really work because it's water soluble. I found out that the some of the vapor condenses on the inside of the dry glass, leaving an oily residue with low boiling point, leading be to the conclusion that vaporizing anime.HCl salts freebases them. I don't intend on putting water in it though, I can just heat that borosilicate glass itself to get a last nice hit after being done for the night. I might try some whether since it could filter out HCl, but I don't really notice much of the HCl anyways. People vape much more HCl salts every day and are fine, so in not too worried. Also: those mini bongs still hit pretty damn hard compared to a bigger one.

2. You CAN hotrail through a meth pipe. I found this thread on bluelight where some kid couldn't get a glass stem for hotrails and figured out that you can heat the bowl directly, put your lips on the stem like normal and just draw the powder in through the carb hole on the bulb.

3. If you got an oil burner with a long and thin stem, isolate it. I wrap a layer of aluminum foil, a later of tissue paper and another two layers of aluminum foil around my stem (in this order from inside to out). It condenses a bit more vapor at the beginning, though when the glass is warm enough it'll slow the amount of condensation in the stem. At the end of the season, just unwrap it and heat the stem directly, getting that one last delicious hit.

4. If you got the technique down, use a torch for vaping stims. It's just so much faster and gives much bigger hits once you learn how to not burn your stims. I use a portable lab grade Bunsen burner (lol, chemistry background), fueled by a mixture consisting of 30% propane and 70% butane. Burns really clean, really hot and has a very finely adjustable flame size. You can also control how much oxygen the flame gets and can therefore control the temperature somewhat. Also, the gas cartridges last for quite some time.

Note: You can get all of the things mentioned on Amazon.

That's it with the tips, hope you enjoyed them.

Personally, I just hotrailed a 30 mg line of a-PVP myself and have to say it vaporizes really well and doesn't even smell/taste too bad. I'm really enjoying it so far, vaping really is better than snorting (my favorite ROA for pretty much almost any other substance). Also, it makes time fly by like crazy. Hexen never did this for me, even in big doses.

I'll try smoking the freebase soon and might report back if it's a big difference to vaping the salt.

Obvious warning though: Don't do a-PVP, kids! Stuff's addictive as hell if you got an addictive personality (also if you don't).