Network cabling through main house hub that include HVAC, plumbing and breaker box lines going upstairs.

Finally having a room available in the house means I get an office for my lab and working from home when it suits me.

I can put a second wireless broadcast point at that end of the house but I'd really prefer installing drops but that means cabling through the main shared wall that connects the basement, first floor and second floor - where the plumbing lines, hvac and electrical runs through from the basement to the rest of the house.

Any advice for something that sounds so daunting?

Posted Sep 1, 2017, 12:31 PM UTC

110
toaster_knight•

That actually makes it easier. There are already penetrations. Get a fish tape and some pull string and have fun.

3
cubliclemonkeyOP•

Good to know. I wasn't sure if having everything so close would be ill advised.

1
toaster_knight•

In a perfect world you would have ac and data lines separated. in the real world it rarely causes an issue unless you are in a high noise industrial environment.

2
YourMomSaidHi•

Try not to physically touch things that vibrate. Keep about 6 inches of separation and you'll be alright

2
metric_units•

6 inches | 15.2 cm

^metric ^units ^bot ^| ^feedback ^| ^source ^| ^block ^| ^v0.7.9

1
YourMomSaidHi•

Good bot

1
GhettoBike•

You might want to buy shielded cable depending on the proximity to electrical lines. If you have insulation, fish tape can be a pain to use but it is cheaper than fiberglass rods or magnepull. You're going to need jacks, a punchdown tool, and possibly an RJ45 crimper if your cables aren't pre-terminated. Also, try to drop cable when you can instead of pushing it up. I hope this helps!

2
YourMomSaidHi•

Shielded cable usually gets people in trouble. If you don't terminate it correctly you will actually make an antenna rather than a shield. Only really well trained people should use it

1