Are there any functional differences between running the Ubiquiti software on the CloudKey vs Computer vs RaspberryPi

Basically as the title says. I have a raspberry pi 2 sitting in a box waiting for some work.

Will this function as completely as a CloudKey in managing and monitoring a Ubiquiti network? I just figure it'd save me $100 if it does.

Posted Sep 17, 2017, 6:26 AM UTC

515
lightbulbjim•

No difference.

2
RedSyringeOP•

Thanks. Can I get the latest software on all of them?

1
JakeTheSnakeMan•

Yes. I've been running the controller on a Raspberry Pi 2 for about a year now and have not had a single issue.

2
RedSyringeOP•

Thanks!

2
kevjs1982•

There is one difference - "Cloud Access feature in this release is not supported on Linux/ARMv6 architecture (for exmaple, Raspberry Pi 1). " https://community.ubnt.com/t5/UniFi-Updates-Blog/UniFi-5-5-20-Stable-has-been-released/ba-p/2011817 Basically you can't connect to a Pi at https://unifi.ubnt.com - if you need remote access you'll need to setup port forwarding or a VPN. EDIT: Just spotted OP says Pi 2 - that's ARMv7 so good to go!

1
boxdogdog•

Dumb question (and I don't want to start a whole new thread about it!) - what do you normally out on if you just set up your APs once and then not use the controller again?

2
rubdos•

Firmware updates, mostly, I think.

2
RedSyringeOP•

Its good for keeping stats and managing all the Ubiquiti gear in one place. If I was just setting up a single AP, I would just install it on a computer for the original set-up.

2
cbuechlerUBNT-cmb•

Stats and alarms primarily.

1
Troubadoure14•

I run it in a docker container on my synology nas. Currently running 5.6.16 and there's no difference as far as I can tell

2
RedSyringeOP•

I've got a a synology NAS too. I haven't heard of running the Ubiquiti software on it though. Was it difficult to set up? That sounds like a pretty elegant solution.

1
Troubadoure14•

It's pretty easy to do. I run goofballl222's image and use the hosts (synology) network settings. This sets up all the ports automatically. You can get up and running with it in about 10 minutes and saves running an extra device on your network

4
RedSyringeOP•

You're a legend. I'll refer to it when I get my ubiquiti gear :)

1
kenperkinsEdgeSwitch User•

Another docker image to consider:

https://github.com/jacobalberty/unifi-docker

Full transparency: I use the above image but I have not objectively compared the two. Jacobalberty's image has 4x the stars fwiw.

1