r/Truckers•
noiradle

tips for snow/ice

first time driving (a big truck) in the winter and i was going through a mountain in colorado on the 50. at one point i was going down a 6% grade with some light snow on the road and some ice patches. i hit a dilemma where i felt like i was braking too much to stay at a comfy 25-30mph and worried about my brakes, so i used the engine brake on low. i’ve always had it drilled into me not to use it in bad conditions but i didn’t see what other choice i had.

what do in these situations? at that speed and with the cold weather would my brakes not be in danger of overheating even with near constant pressure? is low setting engine braking relatively safe at low speeds? thanks!

Posted Nov 23, 2017, 12:57 PM UTC

622
grumpy2861•

Your brakes can take a lot more abuse when it's freezing out. Don't worry about over heating them as much in winter

6
CB_Rubber_DuckyDriver [Hazmat/Tanker]•

You can use engine brakes on ice. You can even use them on high going downhill. Never use them into a turn on ice. Never hit your govenor downhill on ice. Never do it on slush either.

You can drive full throttle on snow.

You should never drive full throttle on ice. It can be done, you just shouldn't. Leave about 3-5 mph from your govenor so you can get in front of the trailer. Always slow down before banked turns and give fuel to dig into the turn. Always commit. Never quick steer.

Never use them on slush.

NEVER EVER engage anything on black ice. Just keep the wheel however you had it and coast as long as you can. No fuel, no brakes, nothing. Neutral bomb it. Glide into a ditch if you gotta.

All of this is bad advice if you drive tankers. The limits are slightly lower.

5
mikejmarvinI'm a Trucker :)•

I always use my engine brake on low in the winter. I've driven in Alaska and the cascades for years. Don't flip it on in a corner. People say not to use it in the winter just downshift. Engine braking does the same thing as downshifting. I've never had a problem using it.

4
robexibDriver & hug machine•

When something is already freezing, overheating it suddenly becomes a lot harder to do.

3
Fuel4UDriver: Bacon Cheeseburger Destroyer•

I won't touch the engine brake in winter. If you've ever lost traction grip while using an engine brake, you wouldn't have any questions.

3
thegreatbanjiniGear Jamming Driver•

Jakes in the snow aren't a problem unless you lock your axles. The sound of em skipping is a bit unnerving, but you have another free rolling axle keeping you straight.

2
Fuel4UDriver: Bacon Cheeseburger Destroyer•

Yah, good for you, 13 years in Alaska and another 3 years running the Cascades. I'm pretty familiar with what a Jake does on snow. I just spoke my piece to answer the question asked. I won't use it. I won't use it because I have used it. You have your opinion, I've got mine. OP can make up his own mind.

3
thegreatbanjiniGear Jamming Driver•

Fair enough m8, you know what's best for you and your rig 👌

3
Fuel4UDriver: Bacon Cheeseburger Destroyer•

Back at you, I'd never second guess a pro driver.

2
tablett379•

The sound of silence.

1
tablett379•

Must be nice running around so light all the time

-1
Fuel4UDriver: Bacon Cheeseburger Destroyer•

I run 105500lbs of fuel.

3
sledge07Large Car Outlaw (fucking special)•

You can all argue and bitch and disagree but this is the one tip that y’all should ALL be giving here. Slow down, be patient, pay extreme attention to all surroundings, put the fucking phone down, turn the fucking radio down and just relax. You can use jakes but not full blown. Usually setting two. If the trailer ever comes out from behind you do NOT slam on the fucking brake pedal. Trailer brakes handle aka Jerry bar is your best friend but don’t jab the fucker. Be gradual.

3
tablett379•

At 20mph we were allowed to be on the brakes all we wanted. Above that they wanted 4 seconds on and 8 seconds off at a very strict place I worked before.

I use the Jake's on high all the time. That's why you left-foot brake. When the Jake's lock up you can feather the throttle to turn them off and apply more or less brake with the other foot. Maybe be going a slower speed and a lower rpm then dry roads.

2
ThirdProcess•

Hmm I'm starting to think the engine brake on my Prostar is different from whatever you are using.

1
tablett379•

It's an isx Cummins that Jake's like the rest. Then turn the fan on to hold back some more

1
SEILogisticsDriver [ask about my bumper]•

Just use your jake

2
tablett379•

And the fan.

1
[deleted]•

[deleted]

1
adventure_dog•

I just got this post up Winter driving, chain, and wind.

Colorado sucks for updating their chain law between 11 pm and 5 to 6 am. If you're out driving during those times and the law isnt up but you feel that you need chains put them on. I end up thdowing chains during those times A lot during the winter because they don't update.

1
LoneCowboy•

usually the problem is the reverse. Chain law is still up but it's just wet. (esp in the Spring when not so cold). See lots of broken chains on those days. If you're going up the hill at 5am and the law is still up and it's wet, it's better just to wait until 6am and see what happens.

2
adventure_dog•

If its up at 1030 pm its going to be up all night. I normally find Vail pass covered in black ice going east bound around 5 am

1
Hvv46h77hh6h•

That explains it. One night I left Denver headed west and didn't see anything about chains. Luckily it was super cold and the snow was dry and I was close to gross.

1