r/psx•
ottguy74

Modded PSX 7001 with MM3 chip, and it only boots backups

So I modded an SCPH-7001 with an MM3 chip, and the unit only boots copies, but not originals. Anyone ever see this? I'm guessing one of my points is bad, but I've double checked them all..... seems correct.

Posted Feb 2, 2018, 12:22 AM UTC

78
Jinzo_9•

I have a modchipped SCPH-9001 that has the same problem.

Some MM3 chips are just poorly made and won't run originals. It's a given, unfortunately.

2
ottguy74OP•

I can't claim to understand the workings of the chips. But I also had it wired in 4 wire mode. Should it not just pass the boot code constantly, regardless of the media I put in? That's why I'm so baffled. But I'll just try installing a new chip when I get one.

1
Jinzo_9•

It depends on a few factors.

Wire gauge might be an issue. Use 30AWG wires for these connections, they always worked on my boards regardless of what kind of chip I was using, not too thick or too thin. Ethernet wires are 30AWG, so if you have any of those laying around, cut some and use them on your board.

A bad soldering job can also be an issue, but you seem to understand what you're doing, so I wouldn't count on that.

Luckily your board still works regardless, so I wouldn't mess around with it too much.

My advice is: get a new chip. Stealth chips are the most reliable ones I've used so far, but they are not that easy to find and the wiring job is harder, but I had 3 units with Stealth chips and they're still working.

1
ottguy74OP•

I bought 2 MM3 chips, and put one in my 7501, that one works flawlessly. But I find it an easier mod, as most of the connections are on very simple solder points.

The 7001 I find a bit trickier for a couple of pins.

I had not modded a systems in almost 17 years I think, and back then, I only did the 4 wire modes.

I'll try again with your Ethernet wire suggestion, I was using wire wrap, which is what I have always used (way back when), but this particular wrap I'm not sure if it was the same size. It seems smaller than the Ethernet wire I just cut.

1
trixter192•

Bad laser.

1
ottguy74OP•

I just swapped the laser with another unit I have working with an MM3, and same symptoms. Copies yes, Originals no

So I took the unit appart, and cut wires 3-4-7 to run it in 4 wire mode, and the symptroms remained the same. Only copies worked.

So I just pulled the chip out completely. Now the system works fine, and plays originals. Copies won't boot now obviously.

But I am confused why in 4 wire mode, it would not boot originals. I'm just gonna start from scratch with a new chip.

1
trixter192•

Wow, thanks for trying. Did you verify all the wires are correct?

1
ottguy74OP•

For sure. I mean, i Know they were correct as far as where I connected them, but pin 4 and 6 are so tricky, that i was wondering if bridging one of these would cause the behavior. I'm just gonna replace the chip.

1