FunForTheTeamOP•

Now for some sanding, then finish with some bee's wax.

2

Looks smooth!

2
FunForTheTeamOP•
1
sabre21asdf•

Is that 3 hours actual cutting time?

1
FunForTheTeamOP•

Total time.

  • Including breaks and interruptions.
  • Also clamping and marking
  • leveling the base, I did the shaping then ran it over a board that I had blackened with a pencil, with a hand rasp I then removed the areas that touched until it was level.
  • once level, the one side was higher and I had to take it down a bit...

What I really liked, was that the blade can really dig into the wood, removing lots of material - but if you lightly run it along the wood, it gently smooths the shapes out giving a pretty good finish.

...and I used it for the convex and the concave - both the inside and the outside of the bowl.

^(Disclaimer: I am in no way affiliated to Arbourteck)

1
sabre21asdf•

Nice

1
FunForTheTeamOP•

Prototypes always take longer than when the product goes into series.

1
FunForTheTeamOP•

....not sure from your comment.

Do you consider 3 hours quick or slow for this project?

I could never have done it in that time without power, I shudder to think how long it would take. Still, 3 hours is a long time for a medium sized softwood bowl.

I wonder what I could charge for it???

1
Michelhandjello•

Have you taken the calipers over the whole thing? You will save yourself a ton of sanding with a couple rounds of measure and trim. I loved me a turbo plane!

1
FunForTheTeamOP•

Calipers are an Idea - what kind would you recommend? (Amazon link?)

I was scared a couple of times that it was getting to thin, but I judged it pretty well. I did the ends quite a bit thicker, because stability and difficult to get into that spot.

Sanding - only by hand and only so much to get it nice and smooth, then I want to get started with my next one. I've got some nice Beech- and Applewood.

1
Michelhandjello•

I am on mobile so no link but search "art advantage calipers" to only saw 8 inch in stainless, but bigger may be better for you. You need a uniform thickness or the bowl has a high chance of cracking.

1