Ceiling fan junction box incorrectly installed

Hi everyone,

So I decided to put up a new ceiling fan in my downstairs den area. I took down the existing ceiling fan but discovered that the existing fan was installation looks very... improper. On one side, the part that's holding the fan was directly screwed into the joint. You can see the screw hole on the bottom side of the picture attached. Also that metal brace seems to be floating... Picture here.

Since this is downstairs, I don't have access from above. My question is, do I call an electrician or a sheetrock guy to fix this issue? Also, what's the proper trade name for a "sheetrock guy" ?

Thanks!

Posted Mar 18, 2018, 8:20 PM UTC

74
Bakert7291•

Typically the box will be a paddle fan box and will be directly screwed into the truss itself, if you're uncomfortable with it I would call an electrician. But it'll be a box like this - https://www.homedepot.com/p/Slater-New-Work-4-in-Direct-Mount-Ceiling-Fan-Box-S116FAN/304270956

There's a couple different styles but for the most part they will have a slot through the center of the box where the truss will run and you'll screw it into the truss for maximum support. They also make a peak box for vaulted ceilings but since this is a downstairs area I'm assuming you don't need that :)

3
Masterhandyman•

If you call an electrician they'll tear open the ceiling and make it the proper way needs to be with some wood behind it but they're going to leave you with some patchwork that you'll probably need to call someone who does drywall repairs. And then you're going to need to call a painter but you're probably best off getting a good handyman that does everything so they can take care of the whole project start to finish

3
Diverminh•

This would be a very simple job for a handyman or an electrician. The box in there looks like a standard box for a light fixture - NOT a ceiling fan. You need to put in the proper box to support the fan. I linked to the proper box you can use.

https://www.homedepot.com/p/15-5-cu-in-Retrofit-Ceiling-Fan-Saf-T-Brace-0110000/204845572

3
hardman52•

That box was never meant to support a ceiling fan, it's just a regular fiber box for a light fixture. If you don't know how to unwire the existing splices and rewire them, you should call someone who does. The place where you bought the fan should have a list of people you can use.

2