squiresuzuki•

Shimano Tourney TY300. $13

https://www.amazon.com/Shimano-Tourney-TY300-Derailleur-Standard/dp/B01K5C6F1U

Need a pic of the hanger (where it attaches to the frame) to tell which type to get, but it's probably the direct mount version.

It appears to have been caused by those two silver screws (the two right next to each other, philips head) not being adjusted correctly.

Watch this video to learn how to do that: https://www.youtube.com/watch?v=UkZxPIZ1ngY

9
theslamprogramOP•

That was fast. It's currently 1 am so I can't go take a picture right now. How can I tell what type it is?

2
squiresuzuki•

One type (direct mount) screws directly into a hole in the frame, and for steel bikes that hole is on a little piece (hanger) that is welded directly on. pic: https://upload.wikimedia.org/wikipedia/commons/4/42/Rear_dropout.JPG

The other type ("claw") kinda slides onto the same slot your wheel goes onto, then is mostly kept in place by your axle. Usually found on lower-end older bikes. pic: http://3.bp.blogspot.com/_SlZtT335XYc/TTb_Vpiu1-I/AAAAAAAAAH8/DnsxG9tmoas/s1600/PC045040.JPG

3
theslamprogramOP•

The screws probably weren't set right (I bought this pre-assembled and didn't know any better on adjusting these types of things), but what broke this was a car that wasn't looking where it was going sending me over my handlebars.

2
squiresuzuki•

Ah, I suppose blunt force will do it too!

2
H4ukka•

That's a Shimano Tourney something something. You'll find the accurate part number on this plate on the derailleur. Depending on how the RD got mangled the hanger might be bent too and would need to be replaced. It's this bit here where the RD screws in.

4
theslamprogramOP•

Thanks for the illustrations. I fell over onto the RD while riding it. Will it be obvious from looking once I take it off if I'll need a new hanger or not?

1
H4ukka•

It might not be obvious since it's a short piece of metal. While it's still on the bike take the RD off and put a straight ruler against the face of the hanger where the RD mounts. The ruler should be parallel with the rear cogs. That is if you don't have a direct mount. If it is bent you should talk with a bike shop. They have the proper alignment tools to fix your bike. Bending a badly bent hanger back might snap it causing further frustration.

1
Jazzboss79•

How did you fuck it up so badly wow I never saw something like this....

It's a Tourney rear derailleur, maybe it's a good excuse to upgrade to something a bit better?

3
theslamprogramOP•

I've never fixed anything on a bike before, but I recently messed this one up pretty bad. I don't really know what questions I need to be asking, and I don't know what information I need to share. I just know that this part is bent and broken and Google only got me as far as what it's called. What do I need to look for in a replacement and how do I install it when it arrives. Thanks in advance for any help and advice.

1
Bovice144•

Replace it with a Shimano Acera. Little better quality but make sure you bend your derailleur hanger back.

1