Shower Enclosure Cement Board Gap Help Request
I am renovating our bathroom which has a standup shower. I have installed cement board on the 3 sides. At the side where the showerhead is, the wall is as wide as the shower and then there is an outside corner which is outside the wet area and will remain sheetrocked. The tiling plan is for large format tile on the walls, probably at least 12x12 and small tile on the shower floor, maybe 1x1 or maybe even pebble.
In installing the cement board, I cut it a little short at the corner and there is now a gap of about 5/8" between the edge of the cement board and the corner: pic 1: https://imgur.com/r2rqVc1 pic 2: https://imgur.com/sCBJjaJ
My plan is to fill that gap with a sliver of cement board set into thinset. Then to thinset over the patch with fiber tape and thinset over that before installing a metal corner bead. Is that the right way to do it?
Question #2 has to do with the bottom edge. Down there, the cement board kind of flares out a little bit: pic 3: https://imgur.com/qgiokLS It looks to me like that flare out will impede the installation of the tile in that area. I'm thinking it would prevent the tile from laying flat right in that corner. Will the thickness of the mortar that the tile sits in be enough to compensate for that flare in the corner? If not, how else can I address this problem?
Thanks for your help in advance. This is my first really detailed post so I hope I included enough information.
Edit: formatting
Posted Apr 19, 2018, 1:31 AM UTC
Just fill it with your thin set mortar and let it dry. Then tile over it applying the mortar as you would normally. If your going to use the corner bead stick it under the tile before you apply the mortar. You could also use strips of tile on the drywall to create the corner and give a "frame" instead of corner bead. And I can't really see the flare out on the cement board but you can check it by dry fitting some tiles and seeing how it looks.
This. The mortar thinset should be enough to offset that flare.