[Hardware]DIY Switch Paperclip jig for RCM mode

Wanted to put this out there for anyone trying to make their own "jig" for putting the Switch in RCM mode. Original idea was by a user at gbatemp forums named Tomman321, so I played around with it and put my own spin on it, and wanted to share here as well in case anyone wants to try it.

I took a paperclip that was sized just right to just touch the inside of the joycon railing on the switch, then cut it into the shape in the pics below

I tried to take several shots to hopefully better convey the shape needed to do this: https://i.imgur.com/QVX3iVb.png https://i.imgur.com/MHpwWSS.png https://i.imgur.com/59a5Kqz.jpg

The idea is to bend it in such a way that it touches the pins when you push it into the slot, while allowing for ease of connecting/removing: https://i.imgur.com/npzj0ZU.png

The end result is a paperclip that I shaped so that I don't have to hold it or connect it in a specific way or angle. done properly, I can feel when it touches the pins, and so far getting the Switch to boot in RCM mode works flawlessly every time: https://i.imgur.com/lIS0Vnj.png keep in mind that you need a paperclip at just the right size to where the clip itself touches against the inner portion of the railing.

Here are a few quick measurements I used with what I had for measuring: https://i.imgur.com/R7GQ6ND.jpg

Hopefully this will help out any DIYers to make their own reliable jig.