Waterborne Paint

What is required to shoot with waterborne paint rather than the conventional urethane base coat? I imagine it requires a different spray gun. What about the primers and fillers before the base coat?

Just curious before my next project if waterborne should be considered.

Posted Jul 19, 2018, 9:39 PM UTC

38
natedawg191•

Prep work needs a little more finesse. Finish blend areas in 1000g or higher. Waterbase really just needs heat and airflow to dry fast. If you have a baking spray both and you buy one of those air blower stands, your in business. Hairdryer works for spray out cards.

Engine cut-ins out side of the booth can take time to dry, or stand there with a hair dryer looking like an idiot for 10min.

Axalta/ Dupont/ spies hecker are really nice products! most colors cover in one coat. I've heard ppg envirobase is a bit more like spraying solvent in that it needs flash time inbetween coats, and doesn't have the best coverage.

Sealers primers and clearcoats are all the same

3
mphouli•

PPG envirobase is a completely different way of painting. You are spraying for color match not coverage, once you get the hang of it the color match is second to none. As far as spraying water goes the panels need to be very clean and you need clean dry air coming into the spray gun. I sprayed solvent for 12 year and water for 8, I would never go back to solvent. As a side note Sherwin Williams water it pure trash. The only thing they have going for them is their P30 primer/sealer.

4
natedawg191•

I'm curious if you can elaborate on spraying for color match.?

The Dupont system we spray a cover coat at about 12psi and then raise the pressure and do sort of a drop coat to get metallics to look good/ not blotchy.

I use a camera/prophet to take a picture of the color, rarely do I even check the color code. It's pretty legit but I do end up tinting most gold, or gunmetal metallics. And pretty much every white tri- coat.

Our tricoats are always way too white, I've been just leaving out 20% of the white in the base, usually gets pretty close.

2
tdiddy123•
2
SnowThrasherOP•

Good information, thank you!

1
dublifeh2o•

Primers sealers and cleaecoats are still solvent based. I spray with sata 5000s (RP would be better) you need atleast 2 guns for base, One for blender and one for color. Blowers help dry the base on humid days. As long as you have good airflow you dont really need any "special" equipment

2
natedawg191•

SATA 5000 rp 1.2 is magic for water. I use only 7 oz of base for a new bumper!

2
PsychonautMIA•

The only thing that's water based is the base coat. Just need a gun that's meant for water as older guns don't have the inner coating so they might rust out, so they say. You need proper airflow or it won't flash/dry.

2