Unifi Switches, LLDP, and Mitel Phones

I work at a MSP that is owned by a rural telecom. We sold a small hospital (less than 200 devices in total) 6 UniFi switches. Our plan is to run the HBPX solution that we also sold them through those switches by just adding our VLAN on them as the voice VLAN. We use Mitel phones exclusively. For some unknown reason the phones keep grabbing the data VLAN, not the voice VLAN that it should grab through LLDP.

We have configured EdgeSwitches with an identical config and the phones grab the proper VLAN with no problems. For the life of me I can't figure out why it won't work on the UniFi switches. Does anyone have any insight?

EDIT: We ended up setting up OUI-based auto-VoIP and it started working. The downside is that we can't inject custom json to make the commands reapply on reboot because UniFi switches just ignore it. Now that we have a way to make it work we are looking into ways to configure OUI-based auto-VoIP on reboot.

EDIT 2: Turns out manually inputting commands for auto-VoIP is NOT the way to go. Apparently UniFi basically reapplies the entire config when provisioning instead of just the few changes you may have made. This means to keep auto-VoIP active you'd have to make sure to reapply the commands after reboot and after provisioning.

Posted Jul 25, 2018, 7:57 PM UTC · edited

85
Loading comments…