Problem with my Ender 3

Discussion

Hello everyone! I just assembled my first 3D printer and honestly, it's a tiny bit of a nightmare. Nozzle scraping the bed a few times gave me a miniature heart attack each time earning a complete shutdown and two days worth of me TRYING to level properly (I'm just not doing the paper trick properly, looks like). However, I figured most the problems out with only one very glaring issue that won't go away:

The printer keeps trying to print off the bed. The first test with the Squirrel Rook I managed to convince it to print in the center, but when I tried to print something else, the printer obstinately places it at the bottom left edge (if you were facing the printer) and begins printing. The model itself is centered in Cura, but it continues to do this. It's currently printing now as I want to do more tests, but I was forced to shove it to the side on the program just so it would print on the actual bed. This is still not centered and FAR less than ideal. Does anyone know how to fix this issue?

Posted Aug 9, 2018, 4:43 PM UTC

46
desrtfxA6 modded|Ender 3|M200|Kossel Linear+|FlSun Cube+ (soon)•

Did you by any chance set: Origin at center?

Should not be checked - like here: https://i.imgur.com/UHpd1Qz.png

2
ContielloOP•

I had the issue before I did and thought that would help as it seemed to work for the Squirrel Rook. I'll be removing it now and seeing what happens next!

1
ContielloOP•

This ended up fixing it! Thank you! Also, say, you wouldn't know any easy way of levelling right? It seems relatively alright, but using the paper trick makes me do several laps around the bed and still not have it level. And by several, I mean six.

1
oldcrowCR-10S | Ender 3•

Watch this video.

Nerys gives one the best explanations of getting the right "squish" and bed adhesion for your first layer. He also describes live-leveling which I find to be a lot more accurate than the paper method.

2
desrtfxA6 modded|Ender 3|M200|Kossel Linear+|FlSun Cube+ (soon)•

Leveling improves with practice.

Some people also replace the stock springs with stronger ones that better maintain level.

1
sellonoid•

I had this same problem with my Ender 3 for the first week. I was totally sure that I had opened the CR-10 printer setup in Cura and simply changed the print volume and saved it as Ender 3 as instructed, and did nothing else, but maybe not. I could see the Cura outputted gcode had X and Y moves that immediately drove the print head right off the bed. Finally convinced that I somehow jacked up my Ender 3 setup AND the “built-in” CR-10 setup, I uninstalled and reinstalled Cura. Then I edited the CR-10 setup to Ender 3 print volume, and saved it as Ender 3. After slicing the same model I could see the gcode looked good, and indeed it printed in the center of the bed.

1