r/olkb•
Daedra

Am I being an idiot? Can't get switches to fit in plate

I joined the drop for a grid planck on Massdrop a couple of years ago but for various reasons including moving house amongst others I've only just got around to assembling the thing.
However I'm failing at step 1, putting the switches into the plate.
At first I assumed this was due to the fact that I've opted to swap to a different switch from what I originally ordered (gateron clears -> Kailh speed pale blues) but i can't get either to actually fit into the plate. I can't quite tell where exactly it is getting stuck but it seems to be on the corner pieces that don't quite look like 90 degree or could be the spur sticking out from one of the horizontals. Basically I can't get either switch to fit into any of the holes, at least not at a pressure that doesn't feel that it will either break the switch or lacerate my palm should I slip.
The drop I joined was in March 2016 and the PCB says it is a rev 4 board.
Image of plate

Posted Aug 12, 2018, 12:33 PM UTC

58
jackhumbertolkb.com•

This was the plate batch that had issues - can you shoot me an email at [email protected]? I can get you a new one. You’re using MX switches, right?

14
DaedraOP•

That would explain it then, nice to know I'm not just being a moron. I'll send you an email, I am using MX switches (specifically I was planning to use Kailh speed pale blues). Brilliant, thanks.

3
rjwmström•

The switches have nudges to lock them into the plate, try depressing them.

3
DaedraOP•

I can't even get the switches started in the plate, I can't even get the bottom of the switch in, let alone get to the locking tab things. It will only rock in diagonally, not push straight in

1
njain2686•

Woah ! that's some customer service.

Applaud.

3
zrevyxDvorak | Too Many Ortho boards to list in my Flair | QMK!•

Yeah, that batch required a but if filing to get the switches to fit. I think I open two Planck with that plate.

2
sir_hookalot•

Whoa, what's up with the jagged plate? Is this common with Planck plates?

1
DaedraOP•

Jack replied saying this was a problem with a particular batch. I actually bought it back in March 2016 and never got around to putting it together so I doubt this is in any way indicative of current production.

1