r/amiga•
at_console

Green goo in my Amiga 600 - is this from leaky capacitors?

Hello,

Today I've inspected my original Amiga 600 after it's been 20+ years in (dry) storage. My plan was to check if capacitors had leaked and either learn how to recap them (I got basic solder skills, a good solder iron, but no heat-pistol) or ship it off to a pro.

While inspecting the motherboard I've noticed green, dried goo on a crystal (Y451, 4.433619MHz PAL Burst, "44.33 KDS 1A") and some spillage on top of another component (Z221, Z222). I haven't noticed any other damage.

​

So here's my question: Is this how damage of leaking capacitors looks like? The Amiga was stored vertically (ports on top), so it could be drips from the capacitors right above them. Or am I dealing with something else here, like a busted xtal? The board itself is clean and the capacitors look okay to my eyes.

The machine wasn't opened or modded before, I broke the warranty seals today. Oh, and it boots and works fine.

​

Pictures:

The damage.

Enhance!

There!

Capacitors and board looks clean... hmm

Same here. Capacitor looks clean, but the xtal looks nasty.

The overall board looks fine.

Posted Oct 20, 2018, 10:28 PM UTC · edited

175
me-tan•

That definitely isn’t capacitor shmoo. When the capacitors let go you start to see the pads get more dull and start corroding.

It’s possibly some kind of paint to mark the component for some reason, that went bad over time. I’d just clean that off with some IPA if that removes it. Failing that try some acetone but make sure that goes nowhere near your case as acetone goes through ABS plastic like xenomorph blood goes through deck plates

2
at_consoleOP•

Thanks for your insight!

I've first tried water with no success. Scratching worked, but, I switched to isopropanol and it came right off, revealing some corrosion behind it. I'm not sure if paint could lead to corrosion: https://imgur.com/iTZ9aRD

During cleaning I noticed that the IDE drive connector was also covered in this stuff: https://imgur.com/zVNV1NI

This starts to look like something dropped on the mainboard during assembly.

​

1
aperezbios•

Looks pretty clearly like surface corrosion to me.

2
me-tan•

It’s possible that happened. I don’t have a 600 so don’t have anything to compare it to, and thus tell you if blobs of goo are normal.

Good luck with your recap, I’m getting ready to do that to my 1200.

1
-wizard-•

That's the sad sign of a case of bad corrosion setting in. Most often it's due to a leaking battery somewhere but it can creep along the pcb...

I also see a really dry, almost broken, smd pad to resistor R215A that'll need rework and/or replacing.

A600 is the only Amiga I've never tinkered with so I can't say if it's close to a battery or not but clean the whole pcb with ipa as already suggested and fix dry solder joints/pads and check for continuity in dodgy areas!

Take care of your old Amigas. I've got a big box of rescued A500 at home that would've been beyond dead just a year or two later, but I've also got an equally large box of Amigas that are beyond repair due to completely corroded pads and vias despite days of repairs... :/

I'd say 100% of my Amigas were damaged by leaking batteries, nothing else. Just remove the damn batteries and clean with ipa, then start thinking of replacing them! It's better to have to reset the time & date at boot than not having an Amiga at all.

1