What did I do wrong

I have a little toaster oven and I finely ground up my bud and spread it evenly on foil (didn’t cover the top) I was going to go 240f for 40 min but after just 10 min the bud almost looked burnt so idk what to do... help? :)

Posted Nov 7, 2018, 5:07 PM UTC

216

You probably want to watch the temperature in the toaster oven. Even regular ovens can be way off the temp they display, toaster ovens are worse. Get a kitchen thermometer (oven thermometer) and you'll have a better idea of the temps you are actually using.

​

Also, the bud will look toasted (brown) after decarbing. This is normal. "Burnt" sounds a bit excessive.

3
drfeelokay•

You don't want the radiation to heat your weed - it'll burn it - you want the air temp to do that for you. So you can lay a sheet of tinfoil very loosely over it.

2
HerbalEnigma•

Folding a foil envelope works best. Poke a few holes so it can actually decarb/dry. You know its a bit too hot when the inside of the packet is very sticky. A sign that resins are evaporating. You can still take it too extremely brown like ABV but it's going to taste like crap.

1
drfeelokay•

Thanks! Question - what is the foil packet doing exactly? I've been told not to make packets because airflow is the main way heat is spread throughout an oven, so you're making it cooler by wrapping it up. I don't have a hard opinion tho.

2
HerbalEnigma•

Consistent and repeatable decarb. Good way to meter how much is vaping/evaporating off. I set it on a glass dish. I doubt it makes it cooler especially if you have a convection oven circulating air.

1
drfeelokay•

I'll try it. I swear to god, I make edibles like 3x/week but barely ever eat them lol, so I might as well.

2
ItsNautilus•

You don’t have to grind it up before you decarb. Whole nugs should stop it from burning so quickly like that. Can’t hurt to try a lower temp next time too

-1
AirflextOP•

I’m not sure how the end product is supposed to look, I vape so I know what good abv looks like but I’m pretty sure it’s supposed to be a lot lighter than abv color right?

2
ItsNautilus•

It shouldn’t be 110% brown, not all the way through at least. It should definitely look a bit toasted tho, it’ll be crunchier too. It should look almost like an herbal tea

2
WingedCrown•

Final product is kinda of a nutty brown color. If it looks dark brown, it is probably too far gone. I usually grind and then seal my flower in a aluminum foil pouch I make, sealed up all around. There are a lot of tutorials on Youtube of the process, so you could check there for a visual.

2
AirflextOP•

So my oven obviously gets way hotter than it says should I just watch it till it’s light brown and go by that? Idk were my oven thermometer but also maybe because my bud is very dry??

2
Canyouhelpmeottawa•

Also the bud is much closer to the heat element in a toaster oven then in a regular oven. That is likely effecting the browning.

1