r/tamagotchi•
Cborne

Tamagotchi P2 Sound Issue

[Question]

I got a 2018 P1 and P2 as a part of the relaunch and some other japanese tamagotchis I missed and some I had as a kid and lost, but that's another story. Anyway, I noticed that my Black/Silver P2 is very loud compared to the P1, so much so that I can hear distortion as if the speaker is playing too loud or the audio is clipping and I can hear it echoing inside the case. It used to only really distort when playing the game but it has gotten worse. I've seen one or two people with this issue but is it common and has anyone checked for the cause? I emailed Bandai support but I don't want to send away my Mimitchi before it dies...

Posted Nov 15, 2018, 8:42 PM UTC

35

Have you tried tightening the screw in the back? A loose lid can cause the vibration you’re describing. I noticed this on a rereleased P1 in clear blue.

2
CborneOP•

I tightened it a good half turn (it was already fairly tight, but didnt want to strip it...) and it seems about the same. Maybe a little better, but still definitely noticeably noisy/distorted? over my 2018 P1 (and both are in turn significantly louder than my vintage 90s ones such as the umi no and angel)

Not sure it would be safe to tighten it further. Maybe an inner screw could be causing it but I don't want to void my warranty :(

2
notwiththeflames•

Yeah.../u/wolfnanaki found out about a month ago that the international versions of the P1 and P2 rereleases have this thing where the speakers and the device are connected by springs rather than wires for some reason. Iffy sound quality is a common issue because of that design.

2
CborneOP•

Ah yeah it kind of sounds like the sound might be bouncing off of a spring or something...I guess I'll have to just send it off and hope the replacement isn't as bad.

2
CborneOP•

I should note here the cause for anyone else who may read this later since I was too curious what was going on and the sound got worse to the point where it was like more distorted than it's ever been so I just gave up and opened it...there definitely are springs holding the speaker up, and the springs are connected to the PCB via solder (or at least it appears to be). The spring itself is the "wiring" for the speaker, and I believe it's made out of copper, so there's no actual wires connecting it inside. The problem with my black one seems to be that there is an excess of solder on the bottom of one of the springs, which causes it to have a natural tilt, which in turn somehow drastically affects the sound profile of the speaker it's attached to. I'm not sure how common this actually is, but if whatever machine they have doing the soldering is not that consistent I can definitely see how this would have happened. My P1 springs are much more straight and it is quieter (although still louder than the old ones, but this is probably due to the new design and speaker).

I can take some photos of the difference if anybody is interested but yeah that's pretty much the cause in my unit. I fiddled with the screws and trying to adjust the springs but the issue seems tied to how it rests at a bit of an angle.

1