r/arduino•
oculus42

Question: Programming a Soldered Surface Mount Chip?

I have picked up some multi-function, IR-controlled LED lights, and am interested in trying to reprogram them. The chip, which is hopefully an ATtiny, is a soldered surface-mount with what appears to be ~1mm pitch, and I'm not sure how to get good, consistent contact on the pins to program it. I've only worked with 0.1" pins, so far.

​

I imagine something exists to do this, but I don't know what to search for. I considered trying to 3d print something to wire up and clamp over the chip, but before I go down that road, does anyone have a better direction?

​

https://i.redd.it/u06mo6wyn9221.jpg

Posted Dec 4, 2018, 2:02 PM UTC

110
triffid_hunter•

I doubt it's a tiny, but you can live in hope.

Solder wires to the pins

5
oculus42OPuno•

Solder wires to the pins

I'm hoping to be able to program multiple of them, assuming I can manage to program it at all. I could solder wires to one for testing, but it wouldn't be a solution for modifying a set of them.

1
[deleted]•

[removed]

1
Triabolical_•

If it were a real Attiny it would have markings.

It's possible it's an illegal clone. But it's more likely it's one of numerous other cheap Chinese processors.

You would need to solve that first. I would start by tracing the circuit and seeing if I could match the pinout.

3
oculus42OPuno•

That's part of why I was hopeful for an ATtiny [clone], because pin 1 (reset) doesn't appear to be connected, pin 8 is wired to positive, and 2-6 are connected... Negative is punched through underneath the chip, so I would probably have to unsolder to see that path.

1
Triabolical_•

I would probably try to solder on some wire-wrap wire and hook that to headers to test it.

Once you have that, I would try to build a jig with some pogo pins and use that to connect to the existing circuit.

2
NoBulletsLeft•

It could be any of thousands of devices. Traditionally power and ground are on opposite corners (pins 4&8 for an 8-pin device) of an IC, so that's not much of a clue about anything.

If you really want to go down this path (why?), you can purchase through hole or SMT debug clips that will clip onto the device.

2
mamunmian•

It is not a microcontroller. It is a dedicated IR remote controller IC with build-in switching device (BJT or FET).

3
chillymoose•

Get yourself some test clips.

2
[deleted]•

[removed]

1