This part that keeps falling off in my car

Posted Dec 19, 2018, 8:23 PM UTC

Posted Dec 19, 2018, 8:23 PM UTC
2013 Chevy impala
Airbox resonator. (Also known as intake resonators - this is probably a better term for one like OPs - depends on where it is located)
They have two purposes. One is to (slightly) muffle the intake noise. The other... this gets a bit complicated to explain but I'll try.... Depending upon the engine RPM and throttle position, the air inhaled by the engine comes as a series of pulses (little gulps as each cylinder is on its intake stroke). At certain RPMs you end up with standing waves in the intake plumbing, which are areas of higher and lower pressure. The resonator will, to a degree, minimise this and aid the engine in breathing in at RPMs where the intake plumbing would otherwise slightly restrict it.
Better explanation here: https://itstillruns.com/air-intake-resonator-do-12156112.html
Explanation of Helmholtz resonance on Wikipedia if you like understanding things by doing lots of maths:
https://en.wikipedia.org/wiki/Helmholtz_resonance
It isn't the end of the world if that part isn't there in terms of engine aspiration, but without it a lot of the air the engine breathes in won't have gone via the air-filter and consequently the engine will end up with a large amount of gritty dust going through the cylinders. This will cause significant premature wear and for that reason the part in your question needs to be firmly re-attached (as in airtight amounts of firmly).
Solved!
Resonators I have seen are upstream of the filter. Are you sure some are downstream as well?
It starts to get to the point of linguistic ambiguity as to whether they're correctly called airbox resonators or intake resonators when they're located right by the airbox. The most common term I've encountered is airbox resonator but that also seems to include the ones slightly downstream of the airbox at the start of the intake tubing that connects to it. Nonetheless, their function and principle of operation is the same.
Edit: I've edited my original answer to include bits of this.
As you can see in this picture (at the top of the assembly)... it looks like you lost the hose clamp that holds it on. You can get a replacement in the plumbing section of any hardware store. Just take the part with you, and make sure you get one that will fit over it. Put the hose clamp around where the part fits into, put the part in, and turn the screw until it's held tightly in place. It should cost about $5 to fix permanently.
The clamp is there, just dirty. Someone overtightened it and crushed the end of the resonator though, so tightening it just pushes the resonator out now.
Looks like there is suppose to be a metal screw strap to hold that down.
"Keeps falling off" -- that implies you have put it back where it belongs before. Where does it belong?
Don't accidentally give him too much credit. Maybe it keeps falling off the roof. :)
right here on the engine
It is for tuning resonance in the intake to reduce noise. The part itself is not really that important, but you need to plug the hole.
The hole doesn't need to be plugged as it is upstream of the filter. Hotter air will get in, which would reduce power, but nothing bad will happen.
It is definitely downstream, it is just before the throttle body. You can see the throttle body in that picture.