r/Gameboy•
jtl_bert

Digital Brightness Controller or Voltage regulator?

I'm going to be doing an AGB-101 mod soon, and I was looking at the different voltage regulator boards at RetroModding. If I'm going to install the BennVenn brightness controller, do I need the voltage regulator board too? Or would that be redundant? Can anyone with more experience with these boards let me know? Thanks!

Posted Feb 5, 2019, 5:28 PM UTC

09
isthisreallyreal•

if you want the screen to have the brightest possible setting, you need the voltage regulator. the brightness controller wont get you that alone.

1
jtl_bertOP•

I suspected as much. Any trouble fitting both boards in the case?

1
isthisreallyreal•

no, there's plenty of room. i would recommend the brightness controller on the front and the voltage regulator on the back. they have photos on their site for how to install them.

1
zasz211•

I started off with Just a voltage regulator and that was to bright for me so I installed at brightness controller to dim the light. In the end I took out the regulator and controller since I only had one to reduce the effect of the other.

1
jtl_bertOP•

Thanks! I've been wondering about it because to be honest I usually play my GBA SP 101 on its lower brightness setting.

So you just have the wire soldered on?

Edit: fixed typo

1
zasz211•

Yeah, that’s all I have done one mine. If I remember right without a regulator you get about 80-85% of the brightness. When your done modding make sure to adjust the trim pot. I did not adjust mine at first because it looked fine but it made a world of difference.

1
jtl_bertOP•

Will do! Thanks for the advice.

1
ClementeKS•

What exactly is the trim pot??

Edit: Also what dou you mean you only had one to adjust the effect of the other??

1
zasz211•

The trim pot is what you adjust on the gba to get a better picture. I’m not exactly sure what it’s changing but it made a huge difference for me.

1