Is there a g-code command to set everything to default settings?
I did some calibrations that, for whatever reason, caused my nozzle to start gouging the print bed instead of properly leveling the bed. I'm looking to start from scratch with calibrating it properly.
Posted Feb 5, 2019, 5:38 PM UTC
29
M502 is reset to firmware defaults I believe
Thanks! Appreciate it
No problem, I think if you've stored any with 500 it'll grab those. Not positive. If you want any defaults for certain values lemme know I've been tinking with this thing way too long. :(
I might just take that offer to ask for help, I spent a couple months trying to get mine working and had to set it aside for a while because I got burnt out trying to make it work.
Best I've found is just setting the right steps, leveling the 3 tower points with G29 P2 V4. Then using R to make it all flat. Gets a good first layer, using a tensioner tool of some sort to make sure the belts are all the same helped a ton too.
Kinda gave up on all the facebook group standards cause it's like 2 hours of tuning for a 30 minute print lol