There are some printed pieces that snap into the 2020 extrusion that it sits on top of. It also sits on top of the electronics brackets and power supply. You could probably (or maybe we're supposed to) use the VHB tape to secure it to those clips. Have a look at "deck_support_clip_x6" under Electronics Brackets.
On the top side the z motor brackets hold it in. Mine is very secure without any kind of tape, etc.
Useful to add that I don't think it can easily be put in place from the top side (at least my build is 12" bed and I couldn't flex the sheet enough to get it under both motor brackets. So put it in before any of the electronics if you can.
I really don't like coroplast so I plan on using a much stiffer board so I'll make sure to install it first. If you had not reminded me I am sure that I would have forgotten.
There are some printed pieces that snap into the 2020 extrusion that it sits on top of. It also sits on top of the electronics brackets and power supply. You could probably (or maybe we're supposed to) use the VHB tape to secure it to those clips. Have a look at "deck_support_clip_x6" under Electronics Brackets.
On the top side the z motor brackets hold it in. Mine is very secure without any kind of tape, etc.
Ok great, Thank you.
Useful to add that I don't think it can easily be put in place from the top side (at least my build is 12" bed and I couldn't flex the sheet enough to get it under both motor brackets. So put it in before any of the electronics if you can.
Yup. Therefore that step is done before installing the electronics and skirts :)
That's a good point. I was too excited and impatient on material shipment to build in order!
I really don't like coroplast so I plan on using a much stiffer board so I'll make sure to install it first. If you had not reminded me I am sure that I would have forgotten.
Thanks