r/ender3•
stevelvd

Bed level test after upgrading springs

Bed level test after upgrading springs

Posted Mar 6, 2019, 12:11 AM UTC

5816
stevelvdOP•

Just installed upgraded springs and went through leveling. This is the best result I've ever gotten, hopefully I won't have to level again for a while!

6
Pukit•

Is your bed PEI or just glass?

1
stevelvdOP•

Glass, this is the one I got:

Glass Print Bed Borosilicate... https://www.amazon.com/dp/B07JKGNB6W?ref=ppx_pop_mob_ap_share

These are the springs:

uxcell 8mm OD 20mm Long Light Load Compression Mould Die Spring Yellow 10pcs https://www.amazon.com/dp/B013G5I4US/ref=cm_sw_r_cp_api_i_JCXFCbEVQG0BV

5
owiko•

I just got my glass bed and my springs are coming on Monday. This is making me drool.

2
Theopholus•

Does your front left clip not get in the way of the nozzle when it moves? If I have one there it drags it all over. Did you set up custom gcode to make it not an issue?

1
stevelvdOP•

Nope, haven’t had it hit the clips at all! I used the cura cr-10 machine setting and adjusted the bed area to 235x235x250. Using the default profiles, just slowed some speed settings down a bit.

1
jku2017•

Loooks... so.... beautiful

1
FlaccidChicken•

Very nice, just ordered a set of those springs in addition to a few other replacements like new wheels and belts

1
Aexus3•

Thanks for this. Just ordered a set myself, I was curious how quality springs would improve leveling, now I know! 👍

1
StudleyAvocado•

im jealous. my bed is far from that level. what a beautiful first layer/

1
Shdwdrgn•

Keep working at it, it's worth the time to learn how to read the results from the bed-leveling prints like OP shows. There are several other posts with more detail, but make sure your springs are cranked down pretty tight and the Z switch is adjusted to the right position. When you do the leveling test prints, first make sure the pad at each spot doesn't come apart -- the filament strands should be completely fused together and not come apart when you bend and twist the print. If your nozzle is too close you'll see rough trenches in the surface of the print -- adjust until the surface is smooth again.

Getting the four corners leveled is pretty easy. The real problem is the warped beds causing the center to be too low, and that's where a glass bed come in handy because you can use aluminum foil to shim up the center until the whole bed is level.

2
stevelvdOP•

Thanks all!!

1
Fant2•

Where can I find this bed level test print?

1
stevelvdOP•

I’m fairly sure I got this from the links on this tomb of 3d printed horrors video:

https://youtu.be/5eqTmb01cBk

1
DoringRosie•

Hi OP, 2 months later, have you had to level a few times again?

​

I got the Ender 3 Pro with stocks springs, finding myself leveling the bed after every 2-3 prints, else the print would literally just fail.

1
stevelvdOP•

I haven’t had to level it since. This reminds me I should run a bed level test print just to check, but all of my prints have been good!

1