r/homelab•
dbear20

S2600CP2 Graphics Card

Help

Looking to install a low end quadro graphics card on a S2600CP2, anyone have any experience getting this to work? Board currently has two E5-2609s but looking at putting in two E5-2637 V2s.

Posted Apr 10, 2019, 5:11 PM UTC

24
wannabesq•

Haven't used a quadro, but Mine's working fine with a GTX card in the second blue GPU slot, the one furthest from the CPUs. The other blue slot is only wired to the second CPU, and the board doesn't like that slot to be the primary GPU for whatever reason.

Other tip, is to update the firmware while the V1 cpus are installed, and once the firmware is updated, it asks you which headers have fans on them. If you don't set it up right, it runs all the fans at 100%. I have my board in a Supermicro 3u chassis, and the fans were crazy loud until I disabled the fans that weren't plugged in. It's still got the stock SAN ACE 80 fans, so they are audible, but nothing crazy when the CPUs are at normal temps.

2
dbear20OP•

Could you point me at a good guide to updating the firmware? This is my first time working with server hardware so i'm a little out of my comfort zone and want to make sure i don't brick it. Also this has a sas/sata raid, will updating the firmware affect anything with the raid or raid controller?

​

I know what you mean about the fans, it sounds light a jet taking off during start up.

1
wannabesq•

The way I did it was to format a usb drive to fat32 and out the firmware files right in the root, not in a folder. Then I booted to the onboard uefi which automatically located the firmware files and started the process, and I just followed when prompted.

1
dbear20OP•

ok thanks

1