Rechargeable 9v battery
Anyone recommend any rechargeable 9v batteries that are cheap and long lasting?
Posted May 21, 2019, 2:51 AM UTC
Anyone recommend any rechargeable 9v batteries that are cheap and long lasting?
Posted May 21, 2019, 2:51 AM UTC
Not really sure but couldn't you just use two 4.7 volt rechargeables instead?
Sure. Here is some NiMH batteries:
https://www.batteryspace.com/9vrechargeablebatteriesseries.aspx
But why not use 3S cell lithium battery? What is your application here?
Power an Arduino for remote radio communication hopefully.
But an Arduino only needs 5v. You can even drive them directly from a single lithium cell down to 3v.
What is the radio device your using?
I'm thinking of using the rf 433 mhz module. Should I get a 5v lithium battery then? I can't find 5v lithium batteries. an I just use a voltage regulator on the 9v NiMH battery to make it 5v?
Lithium batteries will be 4.2v fully charged and down to around 3.3v on the low end. You can easily power 3.3v modules like the Pro Mini 3.3v off the battery itself.
If you need 5v or higher, you can use a boost converter. I picked up these recent, but haven’t put them in a project yet: https://www.amazon.com/dp/B01N6EKHZR
What voltage does your 433Mhz module need?
What is everybody's take on using usb Powerbanks to power an Arduino Uno? Is it a viable alternative to using classical rechargeable batteries.
You just need to make sure the power bank's auto-off feature (if it has one) does not trigger when the Arduino isn't drawing enough.
I have a similar setup using NRF24l01 modules and a single lithium cell with 3.3v regulator on a custom 8mhz board(but you could easily use an 8mhz pro mini). The same setup works for CC1101, SE8R01, and the super cheap 433mhz transmitter/receivers. You could also use an inexpensive 5v boost circuit, though I've had mixed results using these to drive a microcontroller directly if you're reading data from any analog pins.
As other suggested, you could also just power a 5v Arduino along with the RF module directly with a 4.2v liion battery, like an inexpensive ICR18650(which can be salvaged from old laptop batteries or power banks or bought new for less than $3 for >=3000mah), and I have had success with this in the past, but since the highest recommended clock frequency is directly tied to input voltage, once the battery voltage drops a little you will be operating out of spec and essentially over clocking the MCU which can cause undesired results. Also if left unattended there will be nothing to stop an unprotected cell from dropping well below the safe discharge point of a lithium cell.
Edit: one advantage I kind of glossed over is the capacity difference... You can get good 2500-3500mAh 18650 cells for the same or less than a rechargeable 9v battery with 15% the capacity. So say you decided to stick to using the onboard regulator and bought two 18650s to wire in series for a total of 8.4v(7.2v nominal), you would spend exponentially more to get a comparable battery life out of 9v batteries. In my opinion unless a device specifically requires a 9v battery there is little reason to use one