r/arduino•
iceag

Powering an Arduino Long Term

If I plan on powering an Arduino outside for a while, should I use a 9v battery connected to a buck converter that changes the input to 5v for the Arduino? I'm assuming this would be better than having it connect to the Arduino directly as heat would be given off as the on board voltage regulator changes the voltage. Or is the heat negligible?

Posted May 29, 2019, 1:26 PM UTC

28
asking_science•

It all depends on what you want to do.

At the lowest extreme (but which serves no practical purpose other than to set a benchmark), you can keep a bare ATTiny MCU alive for 12.8 years (holy crap!) on a single coin cell battery @ 225mAH

The same battery should keep the same MCU alive for

  • 17 days active (full tilt), 31 days active (typical) or 94 days idle @ 1MHz
  • 4 days active (full tilt), 6 days active (typical) or 27 days idle @ 4MHz
  • 1 day active (full tilt), 3 days active (typical) or 9 days idle @ 8MHz (voltage adjusted)

All of this is gleaned from the data sheet. Everything you need to know is always in the data sheets, you just have to calculate and adjust according to your requirements.

3
triffid_hunter•

9v battery won't last particularly long, but the onboard reg will waste half the power as heat. Can use a buck if you like, LM2596 is popular

1
[deleted]•

[removed]

1
Zoudenprofessional tinkerer•

A better option is an 18650 battery and trying to run everything at 3.3V. The arduino uses less power at lower voltage. What else are you powering?

1
Enlightenment777•

linear voltage regulators - HEAT depends on the amount of current going through the linear voltage regulator. The lower the current the less the heat, the higher the current the more heat.

Rectangular 9V batteries suck, because they can't supply very much current. 5 or 6 AA batteries in series is much better.

1
iceagOP•

Should then the current of the AA batteries be high and the resistance low so it equals 5 V?

1
tugrumpler•

It's negligible at the power levels we're talking about here. Furthermore it's series-pass shunt regulator is probably more efficient than a dc-dc at such low power.

1
threephase03•

Can you use a power brick for charging a phone?

1