VPC Constellation Delta Twist/Z-axis issues
Hey guys,
I've got a VPC Constellation (WarBRD base + Constellation grip) that has been working fine - and then suddenly the twist/z-axis stopped working completely. I've done multiple firmware upgrades to "reset" the base but the VPC software simply won't register any twist input. The Z axis is stuck at 100% and doesn't register any move at all.
I've also recreated the profile several times, saved and loaded the config to the stick. But no luck.
Anyone else seen behaviour like this?
Apart from this problem, the stick is amazing.
Posted Jun 9, 2019, 4:39 PM UTC
32
Have you tried reseating the grip into the base?
I have the same set up. My issue was after a while my aggressive movements jarred the pins loose a bit. All I needed to do was remove the grip, check pins for bends or breaks (had none) and reseat correctly.
Thanks for your support!
Yes, I've done this several times. Also pulled out the connector properly and really pushed it down.
No broken pins either.