r/ebikes•
Maxforce12

Do all types of BMSs work with regenerative braking?

I am planning on building a 60v battery and my controller supports regenerative braking. I was wondering if I need a special type of BMS for regenerative braking to work. I was looking at this BMS and also this BMS. I am a bit confused because this BMS does not seem to have a place to put a charging wire like other BMSs I have seen before. I am guessing for a charging wire I should just connect two more wires to my discharge wires?

Posted Jun 14, 2019, 12:08 AM UTC

23
natermer•

If you are going through the bother of building a battery get a bluetooth BMS. They also support a serial to USB adapter for hooking it up a regular PC.

When a normal BMS fails or shuts off the battery.. you have no way to know what happened. You don't know if it's still working or not. Usually the only sign of a issue is that it just shuts off and won't charge. Doesn't give you any feed back.

​

Most of the time for regen you don't worry about it. BMS will allow the battery to recharge over the output.

3
PROLAPSED_SUBWOOFER72V 29Ah•

On most BMS the balancing circuit is powered on only when there’s power detected from the charger- wire, because balancing is only done while charging, specifically at the final stage of charging. Balancing is not really necessary for regen, as the regen is never going to fully charge/overcharge the battery unless you’re going straight down a mountain with a freshly charged battery.

2
ebikr•

All? No.

1