Is there a way to reset capacity runway graphs?

I've migrated 320 VMs into a new Nutanix cluser & this has taken about half of our available resources...

The result of this rapid migration is that prism capacity runway graphs show that we are going to run out of resources rapidly. However now that the migration work is done, the pace at which resources will be used up is going to be much, much slower.

Does anyone know if there is a way to restart/reset the capacity runway graphs so that they give a more accurate reflection of resource usage from this point on? Thanks.

Posted Jun 19, 2019, 1:35 PM UTC

29
Tickly_Gobshite•

I don't believe you would need to do that. If I understand correctly it analyses trends and it thinks that if you carry on at that pace you'll run out of resources. Over the next few days when the trend returns to normal operation it should realise that and adjust itself appropriately

3
DurhamNeilOP•

Thanks for the response. I think I'm being too eager. I need wait. :D

2
scobb13NCP NCSE L1/L2 NCSX•

Definitely let the cluster normalize and check it again in a week to see what is shows then.

2
onepost4meNCSX•

Your cluster is busy digesting. Let nature run its course and you should be in a better spot in some time.

2
gdo•

I had this issue too. I contacted support and they informed me there is no way to reset the logic so that it doesn't alert for this. The only solution is to disable the alert called,"Cluster running out of memory alert." It was suggested that after 21 days to re-enable it. That is how long it days for the old data (almost no cluster usage) to fall off.

2
DurhamNeilOP•

Thanks for replying. Will do that.

1
qrave•

Seems like you’ve received the right answers here. Out of curiosity how did you migrate them and was it from esx/hyper-v to ahv?

1
DurhamNeilOP•

Both our old hardware & new Nutanix setup were running ESX. (ESX 6.5 on old, and ESX 6.7 on nutanix)
We'd disconnect one of the old hosts at a time from the old vSphere installation and remove it from the old vSphere inventory. Then add the old host into our new vSphere installation with the Nutanix nodes in it. One at a time, we'd do a compute & storage vMotion on the VMs into Nutanix.

Almost all migrations needed no down time. Over a few weeks, all our old legacy SANs were evacuated.

The whole process was very smooth & I'm loving our Nutanix hardware. :D

1
qrave•

Tidy! Any plans to move to ahv?

1