Kinetics of EC reaction

So my research now involves trying to find the rate of a chemical reaction after reduction of starting material. The general reaction is O + 2e⁻ ⇌ R, R + X ➞ Z, and I want to find the rate of R + X ➞ Z (eventually as I change what X is). I think that I can approximate this as O + ne⁻ ⇌ R, R ➞ Z when comparing electrochemical model systems?

The basic explanation for how people calculate this rate (from what I've seen in various textbooks), is to look at the ratio of forward and reverse peak currents for O + ne⁻ ⇌ R as a function of scan rate. Based on this ratio and the amount of time between the forward and reverse scan, you should be able to calculate the rate of R ➞ Z. The problem I'm having is what formula am I supposed to plug these numbers into? All the textbooks/chem. ed. papers/online descriptions of CV I've found so far stop at this qualitative explanation (including the recommended one by Bard and Faulkner, which I've tried).

People keep citing a paper from Nicholson and Shain from 1964 (see Analytical Chemistry, 1964, 36, 706) which has mathematical solutions to various chemical systems. I have read this paper. I do not understand this paper. Here's what I do have figured out:

  • my reaction of interest is probably an example of case VI (O + ne ⇌ R, R ➞ Z) so that's the section I've mainly been focussing on.
  • on page 719: "a working curve could be constructed for the ratio of peak currents ia/ic as a function of kτ [τ = time between E1/2 and switching potential] (Figure 12), and if E1/2 is known, a rate constant can be calculated from a single cyclic curve.
  • Figure 12 shows a plot of kt vs ia/ic, and Table XI on the same page has a list of values from the table What formula did they use for to make this curve? I assume that there must be a formula, and then I can plug in ia/ic (which I know), calculate kτ, divide the result by τ (which I also know), and get the k I want out. But I can't find the formula anywhere in the paper. Just a lot of tables for "current functions" (which I also don't understand what X(at) is supposed to be).

Please help, or at least point me in the right direction.

Posted Jul 3, 2019, 7:47 PM UTC

32
[deleted]•

Refer to the Butler -Volmer equation. A google search can explain it better than I can.

1
Wraith007•

My recommendation to help you digest this dense paper is not to start off by looking at Case VI. I would start by fully understanding the math behind Case I and II before moving on. Also the introduction to Coupled Chemical Reactions on page 712 is a useful starting point to understand how the final cases 3-8) can be related back to the cases 1 and 2.

​

Much of your confusion seems based around which equations are relevant to calculating the experimental current as a function of experimental voltage. This paper systematically goes through the solutions of the complicated partial differential equations and boundary conditions for the different EChem conditions as described in table IV. Case I does a good job of explaining how these problems are solved. Once the boundary conditions and PDE's are setup they are solved and displayed in table 5 (notice all the use of X(z) which is a function that represents the solution of an integral that can be looked up in later provided tables).

​

Equations of the form of 25, 47 show the value in calculating these X(z) functions as the current calculations can be done very quickly. The equations 23-24 and 45-46 related the dimensionless current to experimental current.

​

Good luck!

1