Persian rice. Why did it take so little time to cook?

Issue: my rice shot through the cooking process in about a fifth of the time, and it STILL burned!

Tahdig recipes online tend to go through these steps:

  1. wash, soak the basmati for an hour or more.

  2. boil for 5-10 minutes, drain.

  3. form the tahdig and cook with the remainder of the rice, covered, on high heat for 10 minutes.

  4. turn the heat to low and cook/steam while covered for another 40-60 mins.

I did a test run while keeping an eye on the cooking process, and I ended up only needing to boil for 3 minutes and cook on med-high for 2 minutes - at which point I smelled it was burning, and quickly decided to abort mission by throwing in the saffron water I'd made and steaming it on verrrry low for just another 5 minutes.

The rice turned out fluffy and fully cooked, saffron water fully absorbed - but infused with the flavor of burnt rice. The extent of the burning could've been worse, but it did kill the enamel pot.

I don't think "the heat was too high" is enough of a reason, as I had it on medium high: 7/8 out of 10 on an induction stovetop.

Maybe the basmati I bought was parboiled already (the package did not note this, or list cooking instructions. Purchased supermarket brand in Spain)? But I was under the impression that most basmati is sold parboiled anyway and assumed tahdig recipes all account for that...? Help!

Posted Jul 24, 2019, 11:50 AM UTC

1210
Tyaedalis•

Tadiq is not easy to cook. I worked in the kitchen with some very talented chefs a few years ago and it took them days to figure out properly.

I’m not sure what your process is exactly, but you want to be using clarified butter (ghee). Butter solids will burn fairly easily. If that isn’t the problem, simply use a lower temperature. Temperatures like low and high are extremely unreliable and vary widely from burner to burner.

8
yamleafOP•

Aha, looks like using a mix of butter and oil was a bad idea then. Thanks!

2
arwinlol•

You don't need to be a talented chef or use ghee (never seen it used), rapeseed oil, lower temperature and more patience is all you need

1
prodevel•

Yeah, no matter how much I try I can't get my flame any lower on my burners. I got a diffuser for tahdig, etc.

1
SJP8•

Which tahdig recipe did you use? Are you putting enough oil on the bottom of the pan? How long are you parboiling for? You don't want to overcook because then the individual basmati grains start getting clumpy/gummy. Also, use a nonstick pot for cooking the tahdig! Doesn't have to be very expensive either. My mom taught me how to make tahdig (she is Persian and makes incredible tahdig) and she is very specific about the pot she uses, and always uses the same pot to cook the tahdig and the rice together. You may have to test a few out before you find the right one. Also, she always uses a generous amount of neutral oil on the bottom, I have never seen her use butter or ghee, though I suppose you could? We both cook on a gas stove, so not sure how hot your stovetop runs, but you may want to go down on temp a smidge. Also, basmati is not always parboiled, we use the kind that comes in a big burlap sack, not sure what brand because my mom is my rice supplier. It takes a bit of time to learn how to make tahdig as there is a lot of trial and error. Good luck!

2
yamleafOP•

Thank you for the tips! I was following this recipe. I quickly ended the cooking process (it was only about 2.5 minutes of boiling) once the rice grains seemed more transparent outside than inside.

What kind of pot does your mom prefer? I'm thinking I could do better next time as I get cozier with the specifics of how this stove/this rice/the pot all work together, but I'm alarmed the test run was so different from the recipes I've seen!

1
SJP8•

So the pot my mom uses looks something like this. I don't know if it's the same thing but basically it's a wide non stick pot with a heavy bottom. Even with the non-stick bottom, you do need to use a fair bit of oil.

1
bleuwaffle•

I wanted to add on and say make sure your using veg or conola oil instead of olive oil. Make sure the rice is completely cooled down after the parboil (I just run it through cold water in the colander). I personally use a rice cooker designed for tadigh. cook it ~15 min, drain and cool, and then proceed with the oil and a little water cover and cook. I found this the most consistent way to do it. Lmk if you have any questions

2
positivitypumpkin•

What fat/oil did you use at the bottom of your pan?

1
yamleafOP•

I was feeling fancy so I used a mix of butter and olive oil. Sounds like that may have been a big contributor to the not-great end result.

1