T1-11 siding buried in dirt

Recently saw a couple ants go in a part of my siding so i decided to remove a decorative piece to find out that the t1-11 siding was going into the dirt. I dug out a couple feet to find out the siding wasn't even covering the entire side but stopped halfway down. It looks like the previous owner must have replaced this at some point because the bones are still in good shape and the siding isn't rotten.

There was no insulation in the wall, if anything there was (dry) dirt going into the wall. The other side of this, is my garage and sheet rock.

What is the best solution for this problem ? How do i stop any rot from happening ?

https://imgur.com/a/F45CPz3

Thank you!

Posted Aug 21, 2019, 3:56 AM UTC

15
distantreplay•

Remove soil 4 to 6 inches below mud sill within six feet of foundation.

1
RaevinnOP•

Right above this is a small deck that leads to the front door. That means there would be a very large gap we would have to walk over to get to the front door. It's an option, but if there's anything we can do to fill it up with dirt again but prevent rot/moisture with some sort of barrier that would be ideal.

1
-cwp-•

Wow that's a large gap. How many feet horizontally do you have that the siding has a large gap?

1
RaevinnOP•

I would say about 10 feet. Luckily it meets up with concrete blocks but for some reason they decided not to use blocks for the garage section.

1
-cwp-•

You could always nail a treated 2x4x10 (or thinner board) to the bottom and caulk it up. Biggest issue is those 2x4's being exposed. I would clean and then paint the siding with exterior paint that was covered by dirt to protect it.

1