Where to mount hi lift mount without looking like a douche bag?
My jeep came with hi lift. It wasn't mounted, and I've been keeping it in my house. Where should I mount it? I'd prefer it not to be seen without looking for it
Posted Aug 23, 2019, 6:11 AM UTC
I worked hard to do the same with mine too. There’s hardly anywhere inside to do it. Right behind the tailgate you can sit it on the shelf and then rig a way to bolt it to your rollbars. I would take the foot off and store it in my tool bag. This method was good/bad. It was outa site, stayed dry and clean so no rust, but I couldn’t slide larger items into the back without picking them up and over such as a cooler. When I went up to 33s I upgraded the rear bumper and got a swing gate for the spare which had bolts for the high lift. That was the best of things. It was outa the way, not in your face like on the hood, but did need to get sprayed off and the paint wore on it over the years.
I'm thinking about getting two of these
TOTALFLOW TF-U600 Natural Finish 6" 304 Stainless Steel Saddle U-Bolt Exhaust Muffler Clamp 6" https://www.amazon.com/dp/B07BK1CCT9/ref=cm_sw_r_cp_apa_i_-09xDbBE0S098
(the size I'll need)
Then drilling a hole through the base and putting a bolt through the hole, with a washer and a wing nut to clamp the lift down
And mounting it my roll bar, tucked as high as the hard top will allow, thoughts on that?
Search amazon for “Hi-Lift Jack RC-875 Roll Cage Mount (For Jeep JK)” It also fits TJs. You can use this to secure it pretty much anywhere.